Coursework Help
Task Analysis including Situation and Brief
Internet/ Existing Product Research
Product Disassembly
Questionairre and Results
Materials, Processes and Finishes e.g.1
Materials, Processes and Finishes e.g.2
Research Analysis and Specification
Initial ideas and Development
You should have 4 pages of initial ideas and 4 pages of development. These must be fully annotated (labelled) and rendered (coloured in).
Initial Ideas and Development help are in a powerpoint furthur down this page. It wil tell you what you need to include...
Initial Ideas and Development help are in a powerpoint furthur down this page. It wil tell you what you need to include...
Manufacturing Specification
Flow Chart
Testing
Photograph of your boardgame in use. Question people and record what people have said and say how you could overcome this if you were to make it again.
Evaluation
Evaluation against Specification (this is not compared with the spec above)
Evaluation Strengths and weaknesses
Below are some of the powerpoints that have been used in your lessons to guide your coursework. Use these to help guide your work.
what_needs_to_go_in_specification.docx | |
File Size: | 12 kb |
File Type: | docx |
BOARDGAME ASSEMBLY
This powerpoint will show you one way of assembling a two fold board game. Two fold meaning it folds in half and then half again.
Below is a past project that was sent to us by the exam board. This scored high however there are some aspects that do not need to be included. Look at the mark scheme below it to see which parts were awarded the most marks.